evive Firmware lets you use DC motor, servo motors and stepper motors using inbuilt potentiometers, slide switches and tactile switches.
It become very easy for users to test motors and set servo angles without coding evive. In this tutorial we will learn how to control servo motors and set 90 degree angle using evive Firmware.
evive has two dedicated servo motor outputs pins. Signal pin of servo 1 is connected to digital pin 44 and servo 2 is connected to digital pin 45.
In the following example, I will be showing you how to control servo through channel 1. Given below is the circuit diagram:
A Servo pin has three wires (Order to be connected in evive, left to right)
Upload the latest firmware into evive using Arduino IDE. If you don’t have firmware installed, download it from here. If you don’t have Arduino installed, go through this page to install Arduino.
Once you have uploaded the firmware into evive, go through the following steps:
Voila! You have successfully learned how to contorl a servo motor using evive firmware.